picture of installation of oil fume purifier impeller

avoid the occurrence of oil smoke that will not cause harm to the human body and health. the installation of the impeller is an important step in the use of the oil fume purifier and the use of the oil fume purifier is very necessary. it is also necessary to use the oil fume purifier in the home kitchen and the large amount of oil fume will not be generated. because the impeller directly affects the good effect of the oil smoke being absorbed. therefore, when installing the oil fume purifier impeller, you need to follow the above specific steps very strictly to ensure that the wrong ones can be installed and tested and verified.

detailed introduction

oil fume purifier is an indispensable home appliance product in the home kitchen. it can effectively absorb the oil smoke generated in the kitchen.

detailed introduction

get ready for the mission

some preparations are needed first. the most important point is to choose the right impeller. normally, the fume purifier impeller can be installed before it is installed. the manufacturer of oil fume purifiers will provide professional impellers and are partially designed and manufactured for the same model of oil fume purifiers. therefore, when choosing to buy an impeller, you must choose a product that is more suitable for the model of other oil fume purifiers.

disassemble and assemble the original impeller

the original impeller needs to be removed first. generally speaking, before the impeller is replaced. the specific steps for disassembling and assembling the impeller are very simple. first, remove the air guide from the body of the fume purification machine, then find the screwdriver to remove the impeller, and pay special attention to putting the screws in a safe place, otherwise it is easy to lose.

new impellers can be installed

next, you can install the new impeller. first, you need to place the impeller in the original middle position and disassemble and assemble the original one.shanghai people forumafter the impeller is present. and tighten the nuts and screws in sequence. when tightening the screws, special attention should be paid to not be too strong, otherwise the body will be easily stuck. in addition, the middle position of the rear impeller needs to be adjusted to make it perfectly fit with the air guide shield.

test verification results

it also needs to pass a test verification, and after completing the 4-impeller installation, it can be installed. to ensure that the fume purifier task is normal. at this time, the air guide can also be reinstalled on the fume purifier and turned on it and be careful not to use it without the air guide shield with the fume purifier installed. if the task is normal, it means that the impeller can be installed and completed 4.

summarize